SINGLE CHANNEL PROGRAMMING
SINGLE CHANNEL PROGRAMMING
Adding or replacing a headset to your Single Channel GOLD Series is a simple 3 step process.
First, you’ll identify & clear the Main headset.
Second, you’ll program your new / replacement headset.
Third, because clearing the Main was necessary to add that new headset, you’ll need to also program each of your existing Remote headsets.
1. Clear the Main Headset
BEGIN WITH ALL HEADSETS OFF.
- Turn on Main by pressing the POWER button until LED is flashing blue. Release.
- Enter Program / Clear Mode:
Press the VOL DOWN button 3 times. Release. Press and hold the VOL UP until LED flashes blue & red. Release.
3. Final Step:
Press and hold the VOL DOWN button for appx. 3 seconds until LED flashes red. Release.
The Main Headset is now ready. Leave Main ON.
2. Program New Remote
MAIN HEADSET IS STILL ON.
- Turn on Remote by pressing the POWER button until LED is flashing blue. Release.
- Program headset:
Press the VOL DOWN button 3 times. Release. Press and hold the VOL UP until LED flashes blue & red. Release.
LED will now turn solid red indicating the headset is programmed.
Helpful hint: Leave the headset ON and set it aside. This will help determine which headsets are programmed, and which are not.
3. Program Existing Remotes
YOU MUST REPEAT step 2 for all Remote headsets.
- When all headsets have been programmed, you may now turn OFF all headsets (Main & Remotes).
Your system is now ready to be powered up at game time. Don’t forget to charge your batteries!