PROGRAMMING
PROGRAMMING
Adding or replacing a headset to your Single Channel EVADE Series is a simple 2 step process:
1. Clear the Main Headset
When programming a repaired or replaced EVADE, the MAIN headset needs to be cleared before a REMOTE can be paired. Follow the steps below to clear the MAIN. All REMOTE headsets should be OFF before starting this process.
- With all system equipment off, install battery in MAIN headset & press power button to turn on (LED flashes green).
- Quickly press volume down 3 times, then press and HOLD voulme up button (LED will flash green/red). The MAIN is now in program mode.
- Press and hold the volume down button for 5 seconds until LED flashes quickly. This “clears” the MAIN headset. (Skip to step 3 at right/below).
2. Program Remote Headset(s)
- Press power button on MAIN to turn on headset (LED flasjes green).
- Quickly press volume down 3 times, then press and HOLD voulme up button (LED will flash green/red). The MAIN is now in program mode.
- Power on REMOTE headset to be programmed (LED flashes green).
- Quickly press volume down 3 times, then press and hold volume up button (LED will flash green/red, then quickly flash green). The LED will then turn solid red. The headset is now programmed. Repeat this step for all headsets to be programmed.
- Once all remote headsets have been programmed, press the power button to turn off all headsets and complete the programming process.