Back
✏ PRINT THIS PAGE
Dbx Full Duplex Wireless System
Dbx Full Duplex Wireless System

HEADSET & CMod PROGRAMMING

Single Channel Systems

BEGIN WITH ALL HEADSETS OFF.

STEP ONE: Clearing the MAIN headset.

  1. With all system equipment off, press the power button on the MAIN headset to turn on, the LED will flash red and green.
  2. Quickly press the volume down button 3 times, then press and HOLD the volume up button the LED will flash red.  The MAIN headset is now in program mode.
  3. Next press and hold the volume down button for 3 seconds until red LED flashes quickly. The MAIN is now cleared, all existing headsets will need to be reprogramed.

Step TWO: Programing Remote Headsets

  1. Power on Remote headset(s) to be programmed, the LED will flash green.
  2. Quickly press volume down button 3 times, then press and HOLD volume up button, the LED will flash red, then quickly flash green. Once the LED turns solid RED the headset is successfully programmed. 

     *Repeat these steps to program remaining Remote headsets.

Once all remote headsets have been successfully programmed, press the power button to turn off all headsets to complete the programming process.

Double Channel Off / Def Systems

BEGIN WITH ALL HEADSETS OFF.

STEP ONE: Clear the MAIN Offense / Defense headsets.

  1. With all system equipment off, press the power button on the MAIN Offense headset to turn on, the LED will flash red and green.
  2. Quickly press the volume down button 3 times, then press and HOLD the volume up button, the LED will flash red.  The MAIN Offense headset is now in program mode.
  3. Next press and hold the volume down button for 3 seconds until red LED flashes quickly. The MAIN Offense headset is now cleared, all existing headsets will need to be reprogramed.

Step TWO: Programing Head Coach & Remote Headsets

  1. Power on the Head Coach headset(s) to be programmed, the LED will flash green.
  2. Quickly press volume down button 3 times, then press and HOLD volume up button, the LED will flash red, then quickly flash green. Once the LED turns solid RED the headset is successfully programmed. 

     *Repeat these steps to reprogram all Offense Remote headsets.

Once all Offense Remote headsets have been programmed, press the power button to turn off all headsets to complete the programming process.

Repeat these steps to program DEFENSE headsets.

Programming the DBx Conference Module Remote

START PROCESS WITH MAIN HEADSET IN PROGRAMMING MODE > SEE STEP ONE FOR DOUBLE CHANNEL SYSTEMS

STEP ONE: Power On the Conference Module.

  1. Turn on the conference module that you want to program.
  2. The channel lights located behind the belt clip will begin flashing green.
  3. (Tip: Remove the belt clip to access the channel buttons).

Step TWO: Enter Programming Mode

  1. Press and hold the Channel 1 button for 5 seconds.
  2. Channel 1 is designated for Offense.
  3. The selected channel light will flash red, then blink green — this indicates that the conference module is now linked to that channel.

Step THREE: Complete Programming

  1. Turn both the DBx MAIN headset and the conference module OFF to save the programming.

Step FOUR: Program Additional Channels (if needed)

  1. To link another DBx MAIN headset for Defense, repeat the same steps above using Channel 2 on the conference module.